Beijer-electronics iX Panel T40 EN Manual de usuario Pagina 22

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 45
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 21
Hardware Replacement
7.4 ReplacingtheDisplay/Display
Cable
The following is needed:
A new display including display frame, see
Available Spare Parts for iX Panel T40
AtorxT10screwdriver
Two plain screwdrivers
Note:
MakesuretouseadequateESDprotection.
Follow the steps below to replace the display/display cable:
1.
Power off the operator panel.
2.
Follow the instructions under Replacing the Rear Cover to remove the rear
cover.
3.
Unlock the flex cable connector by pressing the connector flanges towards the
cableanddisconnecttheflexcableandtheplaincablefromthepowercard.
The connector must be unlocked on both sides before removing the cables.
power card
flex cable
plain cable
4.
Gently press the power card towards the top of the panel as shown in the
illustration above to release the power card from th e power card hold ers. Then
tilt the bottom of the card away from you.
5.
Disconnecttheflexcableonthebacksideofthepowercardandremovethe
power card.
BeijerElectronics, MAEN004
22
Vista de pagina 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 44 45

Comentarios a estos manuales

Sin comentarios