Beijer-electronics iX Panel K60 EN Manual de usuario descargar pdf (Pagina 30)

Hardware Self Test

9 HardwareSelfTest

The self-test program can be used to test aspects of operator panel functionality

and the communication ports. To run the test you will need:

• Test plugs; see Tes t p l u g d ra w i n g .

• 24 V DC, min. 3 A .

Follow the steps below to run the self-test program on the operator panel:

Power off the operator panel.

Go to the self-test. Set the mode switches to the self-test positions, see the table

in the Mode Switches section.

Power on the operator panel and follow the instructions at the bottom of the

display.

When using the test plugs, make sure all LEDs on the 9-pin and 25-pin

D-subs are on.

When the self-test is ﬁnished, power off the operator panel and set all mode

switches to the OFF position.

If an error occurs during the self-test, try to fault trace. See Fault Traci

ng.

BeijerElectronics, MAEN001

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 44 45

Sin comentarios

Beijer-electronics iX Panel K60 EN Manual de usuario Pagina 30