
Hardware Replacement
7.3 ReplacingtheRearCover
The following is needed:
• Anewrearcover,seeAvailable Spare Parts for iX Panel K60
• AtorxT10screwdriver
Note:
MakesuretouseadequateESDprotection.
Follow the steps below to replace the rear cover:
1.
Power off the operator panel.
2.
Follow the Replacing the Battery instructions to remove the battery.
3.
Remove the rear cover of the operator panel by loosening the 4 torx screws.
4 x torx screws
4.
Re-assemble with the new rear cover in reverse order.
BeijerElectronics, MAEN001
21
Comentarios a estos manuales