Beijer-electronics QTERM®-A12 Manual de usuario descargar pdf (Pagina 24)

Installing the Terminal Installation

QTERM-A12 Terminal

the back panel may indicate the orientation. If not, you can determine which side should

be at the top by the position of the serial port(s) on the back panel as follows:

• Landscape

When looking at the front of the unit, the back panel serial port(s) should be facing down.

• Portrait

When looking at the front of the unit, the back panel serial port(s) should be facing left. Refer to

Figure 4 for an example of a landscape installation.

3. Install nuts and washers onto each of the six mounting studs. Torque all nuts to 67.8 N cm

(6 lbs in) to create a seal between the terminal gasket and the panel. Avoid overtightening

the nuts.

Figure 4

Modular QTERM-A12 Mounting

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 37 38

Sin comentarios

Beijer-electronics QTERM®-A12 Manual de usuario Pagina 24