Beijer-electronics QTERM®-A12 Manual de usuario descargar pdf (Pagina 20)

Cutting Out for Panel Mount Installation

QTERM-A12 Terminal

5.1 Cutting Out for Panel Mount

5.1.1 Standard Version Cutout

The standard version cutout is to be used with QTERM-A12 models that have a factory-

installed front bezel.

The standard QTERM-A12 terminal can be mounted in panels from 0.8 to 10 mm thick. No

screw holes need to be drilled to install the terminal in the panel. Make a rectangular hole in

the panel using the following dimensions.

OTE

☞

See the “QTERM-A12 Cutout and Mounting Guide” insert that was included in the box with

the QTERM-A12 for installation instructions. Printed on the back of the insert is a cutout tem-

plate that can be used to trace the cutout area onto the housing panel.

Figure 1 is a diagram of the landscape cutout. After the cutout is complete deburr any rough

edges prior to mounting the terminal

Landscape Portrait

Horizontal: 302.5 ± 1 mm Horizontal: 254.0 ± 1 mm

Vertical: 254.0 ± 1 mm Vertical: 302.5 ± 1 mm

Figure 1

QTERM-A12 Landscape Cutout (units: mm)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 37 38

Sin comentarios

Beijer-electronics QTERM®-A12 Manual de usuario Pagina 20