Beijer-electronics iX Panel TA70 EN Manual de usuario descargar pdf (Pagina 29)

Hardware Self Test

9 HardwareSelfTest

The self test program can be used to test aspects of operator panel functionality

and the communication ports. To run the test you will need:

• Test plugs, including two Ethernet test plugs; see Te s t p l u g d ra w i n g .

• 24 V DC, min. 3 A.

• SD card

Follow the steps below to run the self test program on the operator panel:

Power off the operator panel.

Go to the self test. Set the mode switches to the self test positions, s ee the table

in the Mode Switches section.

Power on the operator panel and follow the instructions at the bottom of the

display.

When using the test plugs, make sure the +5 V DC LED on the RS422 test

plug and the LED of the RS232 test plug are on.

When the self test is ﬁnished, power off the operator panel and set all mode

switches to the OFF position.

If an error occurs during the self test, try to fault trace. See Fault Traci

ng.

BeijerElectronics, MAEN012A

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 44 45

Sin comentarios

Beijer-electronics iX Panel TA70 EN Manual de usuario Pagina 29