Beijer-electronics iX Panel TA70 EN Manual de usuario Pagina 27

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 45
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 26
Service Menu
8ServiceMenu
The service menu for the operator panel can be accessed before a project is
downloaded, or by setting the mode s witches in mode 1000. The location of the
mode switches is described in the Mode Switches section.
8.1 ServiceMenuinanEmptyPanel
When no project is loaded in the panel memory, the panel will boot, displaying the
Welcome screen. Press anywhere on the panel display to enter the service menu.
8.2 ServiceMenuinaPanelwith
Project
When a project is loaded in the panel memory, the panel will automatically start to
execute the project. To display the service menu at boot-up:
1.
Disconnect the power supply from the panel.
2.
Set the mode switches in mode 1000 (Service Menu mode).
3.
Connect the power supply.
When the panel boots up it will suggest to go into the Touch Calibrate mode.
This ensures that it will be possible to recover from a bad calibration.
4.
Press anywhere on the panel display to interrupt the timer and to enter the
service menu.
5.
Make desired settings in the ser vice menu.
6.
Disconnect the power supply from the panel.
7.
Set the mode switches in mode 0000 (Run mode).
8.
Reconnect the power supply.
8.3 ServiceMenuOptions
The following options are available in the Service Menu:
8.3.1 IPSettings
The panel has two built-in Ethernet ports, according to the drawing below. For
each port, select to obtain an IP address automatically via DHCP, or specify an
IP address for the first Ethernet port.
Port 1
Port 2
The por t that is currently connected is recognized by a *.
BeijerElectronics, MAEN012A
27
Vista de pagina 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 44 45

Comentarios a estos manuales

Sin comentarios