
Hardware Replacement
7.4 ReplacingtheDisplay/Display
Cable
The following is needed:
• A new display including display frame, see
Available Spare Parts for iX Panel T60
• AtorxT10screwdriver
Note:
MakesuretouseadequateESDprotection.
Follow the steps below to replace the display/display cable:
1.
Power off the operator panel.
2.
Follow the instructions under Replacing the Rear Cover to remove the rear
cover.
3.
Unlock the two flex cable connectors by pressing the connector flanges
towards the cable and disconnect the flex cables and the plain cable from the
power card. The connectors must be unlocked on both sides before removing
the cables.
4.
Disconnect LED cable, if applicable.
plain cable
power card
flex cables
LED (on some models)
5.
Gently press the power card towards the top of the panel as shown in the
illustration above to release the power card from th e power card hold ers. Then
tilt the bottom of the card away from you.
6.
Disconnecttheplaincableonthebacksideofthepowercardandremovethe
power card.
BeijerElectronics, MAEN005
22
Comentarios a estos manuales