Beijer-electronics iX TxA EN Manual de usuario descargar pdf (Pagina 9)

TxA Maintenance

3 TxA Maintenance

3.1 Software

Maintenance of the TxA is similar to maintenance of the other iX Panel, with a few

important differences, described in this document.

It is possible to update the TxA wit h new system software and to make service

settings such as touch calibration, IP settings, self t est etc. These acti ons are

performed by following the procedures des cribed below.

3.1.1 Entering Update Mode

In order to update the system software of the iX Panel, you ﬁrst have to download

the new image from the Beijer Electronics website to your PC.

Follow the steps below:

• Hold a ﬁnger anywhere on the touch screen when applying power to the

panel. After a few seconds the following message is displayed:

– Enter update mode?

– Release touch.

• Release the ﬁnger from the screen. The following message is displayed:

– Touch screen to enter update m ode

• Touch the screen once with a ﬁnger to enter the update mode. Otherwise the

panelwillstartinnormalmodeafter5seconds.

Now the update screen is shown and the panel is ready for image update, according

to the instructions on the screen.

Detailed information about the upgrade procedure is available in the iX Developer

help ﬁle, in the Operator Panel Upgrade chapter.

3.1.2 Entering the Service Menu

Perform the following steps to enter the service menu:

• Apply power to the panel

• When the hourglass sy mbol disappears, press a ﬁnger on the screen and hold

until the touch calibration screen displays the following message:

– Tap anywhere on screen or touch calibrate will start in 10 seconds.

• Lift the ﬁnger and press onc

e again to enter the service menu

Beijer Electronics, MAEN021

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 18 19

Sin comentarios

Beijer-electronics iX TxA EN Manual de usuario Pagina 9