Beijer-electronics iX T7AM EN Manual de usuario descargar pdf (Pagina 5)

Safety Precautions

• To make wiring connections to the power supply connector, follow the table

with cable and torque speciﬁcations below:

TerminalBlockNo. WireSizeAWG TQLb.In.

X1/X100Phoenixconnecto rs AWG30-12 5-7

X1/X100Anytekconnectors AWG24-12 3.5

• ThesedevicesareClass2suppliedprogrammablecontrollers(industrialPCs)

for the use in industrial control equipment and are intended to be (front)

panel mounted (Type 1 and 4x for indoor use only).

1.2 General

• Read th e safety precautions carefully.

• Check the delivery for transportation damage. If damage is found, notify the

supplier as soon as possible.

• Do not use the operator panel in an environment with high explosive hazards.

• The supplier is not responsible for modiﬁed, altered or reconstructed

equipment.

• Use only parts and accessories manufactured according to speciﬁcations of

the supplier.

• Read the installation and operating instructions carefully before installing,

using or repairing the operator panel.

• Neverallowﬂuids,metalﬁlingsorwiringdebristoenteranyopeningsinthe

operator panel. This may cause ﬁre or electrical shoc k.

• Only qualiﬁed personnel may operate the operator panel.

• Storing the operator panel where the temperature is lower/higher than

recommended in this manual can cause the LCD display liquid to

congeal/become isotopic.

• The LCD display liquid contains a powerful irritant. In case of skin contact,

wash immediately with plenty of w ater. In case of eye contact, hold the eye

open,ﬂushwithplentyofwaterandgetmedicalattention.

• Theﬁguresinthismanualservesanillustrativepurpose.Becauseofthemany

variables asso ciated with any particular installation, the supplier cannot

assume responsibility for actual use based on the ﬁgures.

• The supplier neither guarantees that the operator panel is suitable for your

particular application, nor assumes responsibility for your product design,

installation or operation.

• It is recommended to turn on and shut down the operator panel at least once

before installing any components/cards or before connecting the operator

panel to external devices, like for example serial devices.

1.3 DuringInstallation

• The operator panel is designed for stationary installation on a plane surface,

where the following conditions are fulﬁlled:

– no high explosive risks

– no strong magnetic ﬁelds

– no direct sunlight

– no large, sudden temperature changes

• Install the product according to the accompanying installation instructions.

BeijerElectronics, MAEN118A

1 2 3 4 5 6 7 8 9 10 ... 24 25

Comentarios a estos manuales

Sin comentarios

Beijer-electronics iX T7AM EN Manual de usuario Pagina 5

Comentarios a estos manuales

Relacionado con productos y manuales para Panel De Control Beijer-electronics iX T7AM EN