Beijer-electronics iX T10A EN Manual de usuario descargar pdf (Pagina 10)

Installation

Connect the cables in the speciﬁed order, according to the drawing and steps

below.

Caution:

• Ensurethattheoperatorpanelandthecontrollersystemhavethesameelectrical

grounding(referencevoltagelevel),otherwiseerrorsincommunicationmay

occur.

• Theoperatorpanelmustbebroughttoambienttemperaturebeforeitisstarted

up. Ifcondensationforms,ensurethattheoperatorpanelisdrybeforeconnecting

ittoth epoweroutlet.

• Ensurethatthevol tageandpolarityofthepowersourceiscorrect.

• Useonlyshieldedcommunicationcables.

• Separatehighvoltagecablesfromsignalandsupplycables.

24V DC

RS232/

RS422/

RS485

24V DC

Controller

Power

Ethernet

– Connect cable A.

– Connect cable B, using an M5 screw and a grounding conductor (as short

as possible) with a cross-section of minimum 2.5 mm

– Connect cable C.

– Connect cable D. The recommended cross-section of the cable is

1.5 mm

Carefully remove the laminated ﬁlm over the operator panel display, to avoid

static electricity that could damage the panel.

Note:

OnlyforiXT10Apanelswithpartnumber630000301:

Whenconnectingtheoperatorpaneltothepoweroutletfortheﬁrsttime,make

surenottointerruptpowerforaminimumof48hoursinordertochargethebattery

completely. Afterthat,t hebatterymaybe chargedpartlyduringashorterperiodof

time.

BeijerElectronics, MAEN017F

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Sin comentarios

Beijer-electronics iX T10A EN Manual de usuario Pagina 10