Beijer-electronics iX Panel K70 EN Manual de usuario descargar pdf (Pagina 29)

Service Menu

9ServiceMenu

The service menu for the operator panel can be accessed before a project is

downloaded, or by setting the mode switches in mode 1000. The loca tion of the

mode switches is described in the Mode Switches section.

9.1 ServiceMenuinanEmptyPanel

When no project is loaded in the panel memory, the panel will boot, displaying the

Welcome screen. Press anywhere on the panel display to enter the service menu.

9.2 ServiceMenuinaPanelwith

Project

When a project is loaded in the panel memory, the panel will automatically start to

execute the project. To display the service menu at boot-up:

Disconnect the power supply from the panel.

Set the mode switches in mode 1000 (Service Menu mode).

Connect the power supply.

Make desired settings in t he service menu.

Disconnect the power supply from the panel.

Set the mode switches in mode 0000 (Run mode).

Reconnect the power supply.

9.3 ServiceMenuOptions

The following options are available in the Service Menu:

9.3.1 IPSettings

Select to obtain an IP address automa

tically via DHCP, or specify an IP address.

The IP address can also be set during

project transfer.

9.3.2 Date/Time

Use the Date/Time Settings dialog to set the time zone, date and time for the

panel.

9.3.3 EraseProject

The erase function will detect if the project is located in the panel memory or on a

memory card. Pressing Erase Project will completely remove the project and all its

components from the panel memor y/the memory card.

BeijerElectronics, MAEN002

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 45 46

Sin comentarios

Beijer-electronics iX Panel K70 EN Manual de usuario Pagina 29