Beijer-electronics BFI-H2 V1.12 Manual de usuario descargar pdf (Pagina 62)

User Guide Revision 1.12

P0-57

Ud / Uq

Internal Value, Contact your local Drive Distributor

P0-58

Load Torque Profile Current Values

Parameter contains the 5 Current values measured during the Load Torque Characteristic Auto-Tune function.

Five entry display: First display – Current at minimum speed

Second display – Current at first measurement interval

Third display – Current at second measurement interval

Fourth display – Current at third measurement interval

Fifth display – Current at maximum speed

P0-59

Frequency input speed

Displays the speed reference from the Frequency input channel

P0-60

Calculated slip speed

Displays the calculated slip speed in Hz or rpm

P0-61

Relay Control Speed Hysteresis

Relay control speed hysteresis

P0-63

Post ramp speed reference

Displays the post ramp speed reference in Hz or rpm

P0-64

Switching frequency

Displays the actual effective Switching frequency. This may be less than the value set in P2-24 if reduced by the thermal fold-back

function (enabled in P6-02)

P0-65

Drive life time

Displays the time for which the drive has been powered up in Hours, Minutes and Seconds since date of manufacture

P0-68

User ramp value

Displays the User ramp value received from the Fieldbus interface. This ramp function is only active when P5-07 = 1 (Enabled)

P0-69

I2C error counter,

Internal Value, Contact your local Drive Distributor

P0-70

Option Module identification code

Identifies Type of Option Module connected to drive option module slot

P0-71

Fieldbus module ID

Fieldbus module Identification Code

P0-72

Ambient temperature

Displays the drive internal ambient temperature

P0-73

24 Hour Timer Value

Displays the value of the internal 24hour counter, displayed in Hours and Minutes. This value can be set using the drive keypad (UP

and DOWN keys when drive stopped) and will be reset to zero on power up.

P0-74

L1 input voltage

Displays the L1 line input voltage

P0-75

L2 input voltage

Displays the L2 line input voltage

P0-76

L3 input voltage

Displays the L3 line input voltage

P0-77

Test parameter 1/2

Internal Value, Contact your local Drive Distributor

P0-78

Test parameter 3/4

Internal Value, Contact your local Drive Distributor

P0-79

Control/boot-loader version

Displays the boot-loader version and motor control library version

P0-80

Specified internal parameter

Displays the value selected by P6-28. Usually used in conjunction with the PLC function.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 71 72

Comentarios a estos manuales

Sin comentarios

Beijer-electronics BFI-H2 V1.12 Manual de usuario Pagina 62

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Beijer-electronics BFI-H2 V1.12